Car bottom loading furnace is made from structure with full aluminium silicate fiber jilt silk rug module built furnace, furnace bottom use of lightweight insulation brick and heavy firebrick lining.
1. Up to 1-2 ton capacity.
2. Uniformity of ± 5 Celsius.
3. Furnace shell made of thick stell plates, welded to structural units.
4. 30 segment prorgammable PID auto controls.
5. PC connecting Micro software is avaiable.
6. Loading on car.
This type furnace is suitable for all kinds of mechanical parts heat treatment. such as: solid solution stainless steel, high manganese steel quenching, valves, flange, pressure vessel, ring rolling stick, steel pipe, steel wire, steel ball, casting, forging, cast iron, roll, blade, high speed steel, tool steel, automobile axle, diesel engine, gearbox, mining machinery, loader bridge arm all sorts of products and so on quenching and tempering, annealing, tempering, normalizing heat treatment .
1100x450x550mm (Width*Height * Depth) The size can be customized
1200 oC (<2hour)
● PID automatic control via SCR (Silicon Controlled Rectifier)power control with phase angle fired, current limiting resistor.
● 30 programmable segments for precise control of heating rate, cooling rate and dwell time.
● Built in PID Auto-Tune function with overheating & broken thermocouple broken protection.
● Over temperature protection and alarm allows for operation without attendant.
± 1 oC
± 5°C over 100 mm @ 1600°C
0-20 oC /min
K type (Ni-Cr to Ni-Si) with 99.7% purity Alumina tube
Spring wire or belt of Fe-Cr-Al Alloy doped by Mo
High quality insulation materials
●Alumina Bubble Brick
●Ceramic Fiber Module
Double layer steel casing with dual cooling fan, surface temperature below 60oC
● steel plate and steel oven door adopt manual or mechanical transmission
● Power cutting off when furnace door open
110V or 220V, 50HZ/60HZ, 1 phases (As per your order)
Net Weight: about 3600kgs
Gross Weight: about 4000kgs
● One year limited warranty with lifetime support. (Consumable parts such as heating elements and crucibles are not covered by the warranty, please order the replacement at related products)
● ATTENTION: Any damages caused by the use of corrosive and acidic gases are not under the coverage of One Year Limited Warranty.
● Cooling rate shall also not exceed 10 °C /min.
● Toxic or explosive gases are not recommended for use with this furnace without necessary safety controls and supervision.
● Small cracks may appear on the surface of the refractory ceramics over extended use. This is a normal occurrence and the cracks may be repaired with alumina coating.
●Refractory door block must be inserted before closing door.
Operation Manual (English version)
K type thermocouple
(The furnace may be operated by PC by installing a control software. )